4 pro+ Surface Instruction for Use (209196 REV 8)
Safety Information
(Warnings continued) Obey these safety instructions to help prevent
injury and/or equipment damage:
• Warning—To help prevent the risk of hospital bed fires, make
sure facility persons follow the safety tips in the FDA Public Health
Notification: Safety Tips for mattress Preventing Hospital Bed Fires.
(US only)
• Warning—Connect the power cord to hospital grade receptacles
only.
• Warning—Do not use the surface in an oxygen rich environment
or with oxygen tents.
• Warning—Incorrect use or handling of the power cord may
cause damage to the power cord. If damage has occurred to the
power cord or any of its components, immediately remove the
surface from service, and contact Baxter.
• Warning—Do not operate the surface in the presence of
flammable gas or vapors.
• Warning—Do not operate the surface in the presence of
flammable anesthetics or nitrous oxide.
• Warning—Before maintenance or service is done on the surface,
make sure to unplug the surface and remove the patient or fully
remove the surface from use.
• Warning—Do not transfer the patient from one bed frame to
another using the surface with the patient on it.
• Warning—Use a minimum of two caregivers to transfer a patient
on to the surface.
• Warning—When you put a patient on to the pro+ surface, make
sure that the opposite siderails are raised or that another
caregiver is present on the opposite side.
• Warning—Do not connect the power cord to an extension cord
or multiple outlet strip. There is a risk of overheating and fire.
• Warning—This product can expose you to chemicals including
Cadmium, which is known to the State of California to cause
cancer and birth defects or other reproductive harm. For more
information go to
P65Warnings.ca.gov.
• Warning—Operate the bed within the stated environmental
conditions; see “Environmental Conditions for Use” on page 98.
To Next Page
Loading...
