pro+ Surface Instruction for Use (209196 REV 8) 45
VERSACARE Bed—pro+ Surface Installation Instructions
Capital Rental
38. Make sure the status indicator is green.
For more information about the indicator
light, see “Status Indicator Light” on page 47.
39. If applicable, make sure the x-ray
sleeve zipper is closed on both
sides of the surface.
40. Make sure the bed is plugged into AC power.
Warning—Do not allow the surface to stay in continuous contact
with the headboard. This could impact the scale accuracy and Bed
Exit performance which could cause patient injury.
41. Make sure the surface is not in continuous contact with the
headboard.
To Next Page
Loading...
