pro+ Surface Instruction for Use (209196 REV 8) 71
900 Beds
11. Route the surface power cord
between the head and seat sections
on the right-side of the bed, inside
the head pivot.
Attach one cord magnet to the
upper frame below the head
section between the lift arm cover
and the accessory support.
12. Attach one cord magnet to the
upper frame behind the head lift
arm.
13. Attach one cord magnet to the
bottom of the upper frame by the
bed power cord.
14. Put the straight section of the bed
power cord into the cord clamp that
is on the surface power cord. Use
the knob to tighten the cord clamp.
Gently pull on the bed power cord
to make sure the cord clamp is
attached to the bed power cord.
To Next Page
Loading...
