pro+ Surface Instruction for Use (209196 REV 8) 79
900 Beds
12. Attach one cord magnet to the
upper frame on the left side of the
lift arm, next to the bolt.
13. Attach one cord magnet to the
upper frame by the bed power cord.
14. Put the straight section of the bed
power cord into the cord clamp that
is on the surface power cord.
Tighten the cord clamp using the
knob.
Gently pull on the bed power cord
to make sure the power cord clamp
is attached to the bed power cord.
15. Route the power cord between the
lower frame and headboard
support.
To Next Page
Loading...
