BENSHAW RSi GM2 Series - Page 24

Installing the Inverter
14
GM2 Series VFD
890054-00-00
Step1 Remove the front cover
The front cover must be removed to access the power and control terminals. Note that the
disassembling procedure of front cover and control terminal cover may vary depending on the
product group. Disassemble each cover in the following order:
Note
If you have installed the remote keypad, remove the plastic cover under the lower-right
part of the control terminal cover, and then connect the remote keypad cable to the RJ-45
connector.
Loosen the screw that secures the front cover. Push and hold the latch on the right side of the
cover. Then remove the cover by lifting it from the bottom and moving it away from the front
of the inverter.