Service Manual
6
6.1.4. Description of the status icons
6.2. Programme initialisation
6.3. Description of the menus
6.4. Setup
6.4.1. Analyser
6.4.2. Communications
6.4.3. Language
6.4.4. Barcode
6.4.5. Users
6.5. Adjustments/Test
6.5.1. Adjust positioning
6.5.1.1. Optical centring adjustment ........................................................................................................73
6.5.1.2. Wash station adjustment .............................................................................................................74
6.5.1.3. Adjusting the arm positioning ......................................................................................................75
6.5.2. Photometry
6.5.2.1. Baseline and darkness current ......................................................................................................77
6.5.2.2. Metrology ...................................................................................................................................79
6.5.3. Scales, bottles and tanks
6.5.3.1. Scale adjustment for determining level. ........................................................................................80
6.5.3.2. Internal bottle verication ...........................................................................................................81
6.5.4. Verication of the dispensation pumps, pumps and valves.
6.5.5. Adjusting the thermostatting systems
6.5.5.1. Wash station thermostatting adjustment .......................................................................................83
6.5.5.2. Adjusting the reaction rotor thermostatting ...................................................................................84
6.5.5.3. Adjusting the tip thermostatting ...................................................................................................85
6.5.6. Barcode reader adjustment
6.5.7. ISE module
6.5.8. Stress
6.6. Utilities
6.6.1. Demo mode
6.6.2. Analyser information
6.7. Recording and maintenance
6.7.1. Historical reports
6.7.2. TAS report
6.8. Exit
7. Maintenance and cleaning
7.1. Cleaning
7.1.1. Cleaning the interior compartments
7.1.2. Checking the uidic connections
7.1.3. Cleaning the water and low contamination waste containers
7.1.4. Washing the outside of the tips
7.1.5. Cleaning the barcode reader window
7.1.6. Wash the heating canal and the canal of the rotor containers
7.2. Maintenance
7.2.1. Checking of the wash station piston pump
7.2.2. Checking of the reagent and sample arms, stirrers and wash station
7.2.3. Checking the sample and reagent rotors
7.2.4. Inspect the cover and the structure
7.2.5. ISE module inspection
To Next Page
Loading...
