bittner XB400 - Address-Ids

To Next Page

To Previous Page

Page 20

2 Technical Features

Pin Function

3, 6 DATA+

4, 5 DATA-

1, 8 Ground

2, 7 n/c

Ampliﬁers with a RS–485 interface are equipped with two parallel ports, PORT1 and PORT2 (RJ–45). To

establish a RS–485 bus topology, PORT1 should be used as an input and PORT2 as the output to the next

ampliﬁer in the chain.

Two LED indicators are active while receiving data (red=RX) and transmitting data (green=TX) over RS–

485.

2.12 Address-IDs

To connect the ampliﬁers to the SXL all ampliﬁers must have a unique address. The address is selected on

the DIP switch at the rear panel of the ampliﬁer.

Multichannel ampliﬁers receive several consecutive IDs. Every ampliﬁer module consisting of two channels

gets one ID.

Caution

After an address change the ampliﬁer must be disconnected from the data port connection and

re-powered to activate the changes!

DIP Switch settings for 2-Channel-Ampliﬁers:

Address SW1 SW2 SW3

ID 1 ON ON ON

ID 2 OFF ON ON

ID 3 ON OFF ON

ID 4 OFF OFF ON

ID 5 ON ON OFF

ID 6 OFF ON OFF

ID 7 ON OFF OFF

ID 8 OFF OFF OFF

DIP Switch settings for 4-Channel-Ampliﬁers:

Address SW1 SW2

ID 1+2 OFF OFF

ID 3+4 ON OFF

ID 5+6 OFF ON

ID 7+8 ON ON

DIP Switch settings for 8-Channel-Ampliﬁers:

Address SW1 SW2

ID 1+2+3+4 OFF OFF

ID 5+6+7+8 ON ON

 2016 Bittner Audio Int. GmbH