EasyManua.ls Logo

bittner XB400 - Configurations; System Settings; Web Interface (Files)

bittner XB400
109 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3 Specifications of the Devices
Page 95
Press Reset (subjacent on the SXL II frontpanel)
Switch the SXL II Off and On again.
During a re-start the SXL II will move the new firmware from the SD card to the internal flash disk.
Caution
Copying the firmware to the SD card with a card-reader unit and putting the card back into the
SXL II will not work! For the installation process an FTP transmission is mandatory.
3.14.10.3 System Settings
The system settings of the SXL II will be stored under the following name:
sxl_usr.s19
Although this system file is stored on the internal flash disk it will be listed in the directory of the SD card
for easy access. It can be downloaded per FTP.
If a system file is copied to the SXL II via FTP (for example a backup copy) the file will be directly stored on
the internal flash disk.
Caution
Copying the firmware to the SD card with a card-reader unit and putting the card back into the
SXL II will not work! For the installation process a FTP transmission is mandatory.
3.14.10.4 Web Interface (Files)
The web interface of the SXL II is made up of several files. These files can be found in the subdirectory Web
of the SD card.
The files may be up- and downloaded via FTP. It is also possible to edit the SD card in a card reader unit
with a PC.
Caution
It is not necessary to re-start the SXL II after the transmission of one or several files of the web
interface is completed. The changes are immediately available after a refresh in the browser.
The update of the firmware of the SXL II may require an update of the web interface to display
possible new functions.
3.14.10.5 Configurations
SXL II Configurations
Every SXL II configuration is stored in a single file on the SD card. SXL II configurations are identified as
follows:
sxl <configuration number> . cfg
The configuration numbers range from 0 to 16.
Example: sxl8.cfg is the SXL II configuration 8.
A .cfg file is only available if the SXL II configuration has been saved under this specific number.
c
2016 Bittner Audio Int. GmbH

Table of Contents