bittner XB400 - Amplifier Functions; Logbook

Page 96
3 Specifications of the Devices
Caution
After its recovery, an SXL II configuration may be called immediately. There is no need to re-start
the SXL II.
DSP Configurations
Every DSP configuration is saved in a single file on the SD card. DSP configurations are identified as fol-
lows:
dsp <configuration number> . cfg
The configuration numbers range from 1 to 50.
Example: dsp23.cfg is the DSP configuration 23
A .cfg file is only available if the SXL II configuration has been saved under this specific number.
Caution
After its recovery, an SXL II configuration may be called immediately. There is no need to re-start
the SXL II.
3.14.10.6 Logbook
The SXL II logs every important event on its internal flash disk. The logbook can be exported via the web
interface (refer to section 3.14.8.9).
3.14.11 Amplifier Functions
The following table shows the parameters available on different amplifier models.
If a parameter is not listed/available for an amplifier, the device will also not feature the corresponding
hardware parts (e.g. relays, sensors, etc.) for it.
Functions (second column) marked with a # are controllable parameters. All other functions are status
values.
c
 2016 Bittner Audio Int. GmbH