Page 82
3 Specifications of the Devices
3.14.8.2 Settings
This page provides access to all parameters of one amplifier and its channels.
Caution
Parameters not available for a specific amplifier model are grayed out.
The tab Settings shows a double arrow. It is being used to extend the main part of the display to show more
parameters of the amplifier.
Parameter Function
Standby Standby On/Off
Power On Delay A delay may be set before powering up the amplifier after receiving the command
In1 and In2* These level values (–90 to +6 dB in 0.5 dB steps) and the level values of the
neighboring channel form a 2 by 2 mixer. It may be used for mixing of both
channels.
Gain Output level (–90 to +6 dB in 0.5 dB steps)
Mute Channel mute On/Off
Inv* Phase shift of 180 degrees
DSP Access to the DSP settings of a channel
* Available only for specific models
3.14.8.3 DSP
The DSP page offers all parameters and the option to save and recall up to 50 configurations. The configu-
rations may be labeled for easier identification.
Each DSP configuration consists of the following:
• 10-Band parametric EQ
• Limiter and Compressor
• Noise Gate
• Delay
• Low und Highpass Filter (Crossover)
The dropdown menu Display Channel in the segment Settings allows for the selection and display of the DSP
settings.
Figure 3.69: SXL II - Web Interface: Copy of DSP Settings
c
2016 Bittner Audio Int. GmbH
To Next Page
Loading...