1 General Information Page 7
Should any part of the equipment show defects in materials and workmanship, including transport damage,
the customer is asked to complain to Bittner Audio. Failure of complaint, however, has no consequences for
your legal claims.
Bittner Audio points out that all specifications may be subject to change without notice and that liability
for incorrect, incomplete or outdated information is excluded. This warranty does not affect your statutory
rights.
Caution
International: Please contact your supplier for specific regional information, as rights and dis-
claimers may vary from country to country.
1.5 Safety Instructions
Caution
To reduce the risk of electrical shock, do not remove the cover. There are no user serviceable
parts inside, refer all servicing to qualified personnel. Replace fuses only with same type. Avoid
damaging the AC plug or cord. Damage may potentially cause a shock hazard. The apparatus
should only be connected to an AC power supply of the correct voltage.
Never isolate the ground of the AC power cord (the non-fused earthed protective conductor) to
eliminate hum-problems.
To reduce the risk of fire or electrical shock, do not expose this apparatus to rain or moisture
and don’t use it in damp areas or near water. The apparatus shall not be exposed to dripping or
splashing water and no objects filled with liquids shall be placed on the apparatus.
The apparatus must be adapted slowly to extreme temperature changes. These extreme changes
can cause inside moisture development that can cause failure and/or electrical shock.
The power fuses are located on the back panel of the apparatus and may be accessed from the
outside. Use only the appropriate fuses as labeled.
Always use safe operating techniques! Incompetent and improper servicing will void the war-
ranty.
Though all Bittner Audio devices are quite simple to operate and are covered by a solid steel
chassis, improper use may be dangerous. Some of the units can put out very high voltages and
a sizable current at frequencies up to 30 kHz. Any connections to the speaker terminals marked
with a „lightning symbol“ shall be made only by an instructed person.
Figure 1.1: Lightning Symbol
1.6 Warranty Terms & Conditions
Bittner Audio warrants this product to be free from defects in materials and workmanship.
Should any part of this equipment be defective, the Manufacturer agrees to repair or replace any defective
part free of charge (except transportation charges) for a period of three years from the date of the original
purchase.
c
2016 Bittner Audio Int. GmbH
To Next Page
Loading...