BK Vibro VIBROCONTROL 6000 - Page 210

Displaying measurements VC-6000
TM
Compact monitor
© VC-6000
TM
Compact monitor Dec 09 C100585.002 Communication Vers. 03 - 23 -
8 Displaying measurements
In principle the procedure for displaying measurements is identical to
displaying parameters. A measurement is a further parameter in a block.
The parameter for measurements is within all blocks that process
measurements, e.g., RMS-, Peak-, BCU- and DC measurements.
The procedure is as follows:
• Select the block for the measurement
• Select the desired measurement parameter
• Display the measurement
In the following example the measured value for a peak measurement is
displayed:
Block level
USER MENU
NEXT
DATE & TIME
NEXT
SYSTEM
NEXT
LOGBOOK
NEXT
OK-RELAY
NEXT
COMMUNICATION
NEXT (repeat until the corresponding
block is displayed
PEAK 01
ENTER BUTTON
Peak 01
Peak-value
ENTER BUTTON
Peak-value
00010.00 mm/s
ESCAPE
Peak 01
Peak-value
Advice:
When no actual measurement is available for some specific reason, a text
message will be displayed instead of the measured value. The text message
will depend on the cause:
„Sensor fault“ or „ no data“ or „Time out“.
