CAUTION!
Risk of burns!
Particularly when used outside at correspondingly high ambient
temperatures and high substrate temperatures, the Bioselect
casing and the individual parts of the separator can become hot
and should not be touched during operation.
Stop the feed and shut down the Bioselect prior to any mainte-
nance and repair work on the Bioselect and the accessories.
Allow the system to cool down completely, if necessary, before
carrying out repair and maintenance work.
Avoid dust formation as this contributes to heat build-up.
NOTE!
Minimum requirements
The instructions described in this chapter are to be under-
stood as the minimum requirements.
— Depending on the operating conditions, further work may be
necessary to maintain the Börger machine in an optimum con-
dition.
— The maintenance tasks detailed in this chapter may only be
carried out by trained personnel employed by the operator.
— Repair work on the Börger machine may only be carried out
by qualified, authorized specialists employed by the operator.
Further operating manuals / supplementary operating manuals
You must completely read the separate operating manuals and/or supplemen-
tary operating manuals for components and/or special versions.
Pay particular attention to all instructions
— on safety,
— on operation and control,
— on repairs and maintenance.
Maintenance and repairs
BA-RC40_EN, 17.01.2024www.boerger.de / www.boerger.com110
To Next Page
Loading...