every 10 years / every 40,000 operating hours
General overhaul (includes checking the carrier shafts)
— Contact Börger customer service or send the Börger machine for a general overhaul
Ä
Chapter 6.3.9 “Other
repairs” on page 167
6.2.2 Lubricant fill level and changing the lubricants
CAUTION!
Health hazard due to residues of dangerous medium inside
and on the Börger machine!
There is an increased health hazard from contact with the
medium and contaminated components.
Generally, the following applies:
— When using dangerous or health-endangering media, take all
necessary safety measures when performing work on the
Börger machine.
— Avoid direct contact with the medium (skin/eye contact, swal-
lowing, inhaling).
— Remove spillage from your skin without delay.
— Do not store or consume beverages, food or tobacco in the
working area.
NOTICE!
Risk of severe material damage if the quench fluid is not
compatible with the medium!
Loss of seal function if the quench fluid is not compatible with the
medium may lead to severe material damage.
— Observe the detailed specifications and instructions on
changing the lubricants in the lubricant list, which is part of
this operating manual, as well as the specifications in the data
sheet regarding the lubricants used.
— Regarding the quench fluid, especially consider:
Due to the possibility, though unlikely, of quench fluid entering
the working chamber and thus intruding on the process itself,
the quench fluid must be compatible with the medium in addi-
tion to the other materials (especially with the material of the
O-rings).
Maintenance and repairs
BA-RC40_EN, 17.01.2024 www.boerger.de / www.boerger.com 123
To Next Page
Loading...