2.12 Safety instructions for maintenance and rectifying malfunctions
WARNING!
Risk of injury due to inadequate troubleshooting, mainte-
nance and repair work!
Inadequate troubleshooting, maintenance and repair work can
lead to severe injury and significant material damage.
— To the extent necessary, amply secure the surrounding area
when performing maintenance. Cordon off the working area
with a red and white safety chain and a warning sign.
— Ensure sufficient installation space before commencing work.
— Keep the installation site clean and tidy! Loosely stacked or
scattered components and tools cause accidents.
— Ensure correct installation where components have been
removed, reinstall all fastening elements and observe the
tightening torques of screws.
— Ensure the following before putting the machine back into
operation:
— Ensure that all troubleshooting, maintenance and repair
work is performed and completed as per the information
and notes provided in this manual.
— Ensure that nobody enters the hazardous area.
— Ensure that all covers and safety features are installed
and function correctly.
WARNING!
Risk of fatal injury if the plant is switched back on uncon-
trolledly or without authorization!
Switching the Börger machine on without authorization or uncon-
trolledly can cause serious injuries.
— Before switching back on, make sure that all safety devices
are fitted and fully functional and that staff are not at any risk.
— Always adhere to the sequence to secure the plant to prevent
it from being switched back on.
Ä
Chapter 2.7 “Securing the
machine against restart” on page 26
Safety
BA-RC40_EN, 17.01.2024 www.boerger.de / www.boerger.com 37
To Next Page
Loading...