6.3.7 Replacing the brush auger
WARNING!
Risk of fatal injury due to suspended loads!
Loads can swing and fall during lifting operations. This can cause
severe injury, including death.
— Never stand under or within the swinging range of suspended
loads.
— Do not move loads unsupervised.
— Only use approved hoists and slings with sufficient load-
bearing capacity.
— Do not use torn or worn hoists such as ropes and belts.
— Do not place hoists such as ropes and belts near sharp cor-
ners and edges and do not tie them together or twist them.
— Put the load down when leaving the operating site.
NOTICE!
Risk of severe material damage due to incorrect installation
and/or dismantling of the brush auger
If no hoist is used, the risk of damage to the wedge wire screen
due to tilting of the brush auger cannot be excluded.
— Only use approved hoists and slings with sufficient load-
bearing capacity.
Maintenance and repairs
BA-RC40_EN, 17.01.2024 www.boerger.de / www.boerger.com 157
To Next Page
Loading...