6.2 Maintenance and inspection
6.2.1 Maintenance and inspection plan
NOTICE!
Risk of material damage due to improper maintenance!
— Also observe the maintenance intervals detailed in the oper-
ating manuals for the drive gear unit, motor etc., which are
included in the appendix.
— Prepare a maintenance schedule adapted to the operating
conditions.
NOTE!
Replacement of the Multi Disc plate
Check the wear limit for the Multi Disc plate!
— The peeling tabs of the Multi Disc plate should have a residual
height of at least 2.5 mm!
— Otherwise, replace the Multi Disc plate!
NOTE!
Maintenance intervals
The following intervals are guidelines. These intervals can be sig-
nificantly reduced depending on the operating conditions.
when necessary
Checking the outer surfaces for dust deposits and dirt
— If necessary, clean the outer surfaces
Ä
Chapter 6.1 “Machine care” on page 111
Checking the wedge wire screen for clogging/contamination
— If necessary, clean the wedge wire screen
Ä
Chapter 6.1.3 “Internal cleaning” on page 116
Maintenance and repairs
BA-RC40_EN, 17.01.2024www.boerger.de / www.boerger.com120
To Next Page
Loading...