4.4.1 Preparation for installation
NOTICE!
Risk of material damage due to non-compliance with the
operating manuals for accessories!
Non-compliance with supplementary operating manuals for spe-
cial equipment or accessories can lead to damage to the Börger
machine.
— If your Börger machine is equipped with special equipment,
then you must first read the corresponding supplementary
operating manual for the equipment or accessories before
carrying out any installation, commissioning, maintenance or
repair work on the machine.
— Read and follow the safety instructions detailed in
Ä
Chapter
2.12 “Safety instructions for maintenance and rectifying mal-
functions” on page 37.
1. Check all specifications in the technical data sheet and only
install the Bioselect if it is suitable for the intended applica-
tion.
2. Apart from the performance data on the separator, also check
that the materials are compatible with the substrate that is to
be separated.
3. If available, replace the transport lock on the gear unit with
the breather system.
4. Check that any accessories for the operation of the Börger
machine are available and make sure that the accessories
are ready for operation according to the operating manual of
the manufacturer.
4.4.2 Setup
NOTICE!
Risk of frost!
Pieces of ice in the separating and conveying unit or the freezing
of the brush auger onto the wedge wire screen can result in sub-
stantial damage to the screen upon resumption of operation.
— Protect the Bioselect and the connections against frost.
Transportation, Storage and Installation
BA-RC40_EN, 17.01.2024 www.boerger.de / www.boerger.com 73
To Next Page
Loading...