NOTE!
Adhere to the prescribed intervals for regular maintenance
and inspections or those specified herein and in the oper-
ating manuals of the components.
— Suitable workshop equipment as well as specified special
tools are essential for carrying out maintenance work.
Ä
Chapter 9.4.1 “Tools / installation aid” on page 184
— Modifications, repairs, maintenance and troubleshooting may
only be carried out when the Börger machine is switched off.
Accidental restarting of the unit must be prevented com-
pletely.
— To the extent necessary, amply secure the surrounding area
when performing maintenance. Cordon off the working area
with a red and white safety chain and a warning sign.
— Also observe any
— supplementary operating manuals
— operating manuals of the components
in the appendix.
— Large assemblies and components must be carefully attached
and secured to hoists when they are removed or replaced so
that associated dangers are minimized. Only appropriate
hoists and lifting media in technically perfect working condition
with sufficient load capacities may be used.
— Never stand under suspended loads.
— At the start of maintenance, repairs or machine care, clean
any dirt or cleaning agents off the connections and screw con-
nections. Do not use any aggressive cleaning agents. Use
lint-free cleaning cloths.
— During installation, always tighten any screw connections that
have been loosened for maintenance and repair work. Tighten
to the prescribed torque, where this is specified.
— Dispose of operating materials and replacement parts in a
safe and environmentally-friendly manner.
2.11.2 Work on the electrical system
Safety
BA-RC40_EN, 17.01.2024www.boerger.de / www.boerger.com34
To Next Page
Loading...