5.5 Emergency shut-down................................................................................................. 102
5.6 Malfunctions................................................................................................................ 103
5.7 Measures following on demand work!......................................................................... 108
6 Maintenance and repairs.......................................................................................... 109
6.1 Machine care................................................................................................................ 111
6.1.1 Cleaning the outside.................................................................................................... 113
6.1.2 Pressure relief.............................................................................................................. 114
6.1.3 Internal cleaning.......................................................................................................... 116
6.2 Maintenance and inspection........................................................................................ 120
6.2.1 Maintenance and inspection plan................................................................................ 120
6.2.2 Lubricant fill level and changing the lubricants............................................................ 123
6.2.3 Lubricating the adjustment mechanism and the bearing............................................. 127
6.3 Repairs........................................................................................................................ 128
6.3.1 Notes on repair work................................................................................................... 129
6.3.2 Removing/repairing the clamping unit......................................................................... 131
6.3.3 Replacing the mechanical seal.................................................................................... 137
6.3.4 Changing the Multi Disc plate...................................................................................... 146
6.3.5 Changing the filter press channel................................................................................ 150
6.3.6 Replacing the wedge wire screen................................................................................ 153
6.3.7 Replacing the brush auger.......................................................................................... 157
6.3.8 Modifying the position of the auger adapters .............................................................. 164
6.3.9 Other repairs................................................................................................................ 167
6.3.10 Maintenance instructions for special equipment.......................................................... 167
6.3.11 Measures following repair and maintenance work!..................................................... 168
6.3.12 Queries........................................................................................................................ 169
7 Disposal...................................................................................................................... 170
7.1 Environmental protection............................................................................................. 170
7.2 Oil, oily waste and grease........................................................................................... 170
7.3 Plastics........................................................................................................................ 170
7.4 Metals.......................................................................................................................... 171
7.5 Electrical and electronic waste.................................................................................... 171
7.6 Final decommissioning................................................................................................ 171
8 Accessories............................................................................................................... 172
8.1 Frequency converter.................................................................................................... 172
8.2 Control unit.................................................................................................................. 173
8.3 Fill level sensor for conical piles.................................................................................. 173
Table of Contents
BA-RC40_EN, 17.01.2024www.boerger.de / www.boerger.com6
To Next Page
Loading...