Bosch Solution 6000-IP - Page 126

Solution 6000-IP  Installation Manual  Device Programming
10-12
Bosch Security Systems 10/22 BLCC615I
Audible Keyfob Panic
Setting this option allows users who have RF keyfobs to
trigger an audible panic alarm via the keyfob.
Report Keyfob Panic
Setting this option will cause the panel to send a Panic
report to the base station when a panic alarm has been
initiated via a key fob.
Keyfob Func Part On
Setting this option will allow keyfob users to arm an area
or all areas of the system using function key 1 on the
keyfob.
i
Note
This option has no effect when using the RF110
SMART RF 2 way keyfobs as these function are
programmed independantly in MENU 6-2-6.
Devices > RF Devices >
Add RF Keypad

MENU 6-2-3
Reserved for future use.
Delete RF Keypad

MENU 6-2-4
Reserved for future use.
View RF Device ID

MENU 6-2-5
This command allows you to trap and view a transmitters
I.D. number when it has been forgotten or it is no longer
legible on the transmitter label. The device being tested
must be compatible with the RF receiver fitted to the
panel.
1) Press [MENU] + [6] + [2] + [5]. The system will then
begin waiting for a valid trigger signal.
Waiting for Trigger!
Press OK or MENU
2) Trigger the transmitter by pressing any button on
the keyfob or by triggering the tamper switch on
any sensor.
Type = Keyfob
Ur1 User 1 Name
RFiD = 123456789
Press OK or MENU
3) To test another transmitter, repeat step 2. A beep
will be heard each time a new RFID is received and
the new number will be displayed.
SMART Keyfob Function

-

MENU 6-2-6
MENU 6-2-6 is used to customise the button functions on
the RF110 SMART RF 2-way keyfobs. Each of the 5 buttons
can be programmed with two independent functions if
required with buttons 1 to 5 being a single press function
and buttons 6 to 10 being hold down functions .
Up to 10 different functions can be programmed.
Figure 27: RF110 SMART RF Keyfob
i
Note
To trigger the hold down function you must press
and hold the keyfob button down for 2 seconds.
1) Press [MENU] + [6] + [2] + [6]. The keypad will
display the following options.
Button Function
Button Assignment
Exit
Press  OK or SAVE
2) Use the up and down arrow keys to select the
Button Function option and press OK.
3) Use the up and down arrow keys to select the
Button to program (1- 10) and press OK. Remember
buttons 6 to 10 are hold down functions.
4) Use the up and down arrow keys to select the
required function from the list of options and press
OK.
The following button functions are currently
available.