Solution 6000-IP
Installation Manual Device Programming
10-13
Bosch Security Systems 10/22 BLCC615I
1 Disabled
2 Disarm
3 Arm
4 Part 1
5 Part 2
6 Door
7 Output
8 Macros
5) Once the button functions have been configured
you need to set the function assignments for each
button. Select the Button Assignment option from
MENU 6-2-6 and press OK. Select the button to
configure and press OK.
6) The type of assignment available for each button is
determined by the button's function.
The button functions Disarm, Arm, Part 1 and Part 2
must be assigned to one or more areas. The button
function Door must be assigned to a door, button
function Output to an output and button function
Macro to a macro.
7) Using macros it is possible to configure a single
button to open multiple doors or to operate
multiple outputs.
MENU 6-2-6 SMART RF Keyfob Function is only
effective when using the RF110 keyfobs. Other
keyfobs have fixed button functions that cannot be
configured separately.
Devices > RF Devices >
RF Site Key
MENU 6-2-9
0 0 0 0 0 0 0 0
This menu allows the installer to assign menu locks
Digiflex RF devices to the site. The default RF site key is
the serial number of the control panel. Use keys [0] - [9]
to program RF Site Key + [OK] to save.
Devices > GSM/GPRS Module >
GSM/GPRS Status
-
MENU 6-5-0
This command interrogates the GSM module and
displays information about the radio and the SIM
installed. The first line is a heading which indicates the
GSM module type that is installed. Typical information
available is details on the installed radio, the SIM provider
and signal strength of the currently active SIM. Is should
be noted that the use of SIM 2 is restricted to reporting
protocols that utilise the dual sim where SIM 2 is a
backup.
GSM/GPRS Module 1 Gi1
IP Addr =10.252.83.178
< Scroll Parameters Here>
Press 0-9 OK to SAVE
The following parameters will be scrolled one at time
through the display.
IEMI=19327130710103097
Radio Model=SL6087
Radio Firmware=Rev 1.96
Radio S/N=If this is available not sure
Provider=Sim1 YES Optus or Sim2 YES Optus
Signal Strength= Sim1 10dB or Sim2 11 dB
Dual Sims Detected
Devices > GSM/GPRS Module >
GSM/GPRS Options
MENU 6-5-1
1 Display Troubles Y
2 Report Troubles Y
3 Delay Reporting Y
4 Alarm On LAN Fail N
5 Lock GSM Band N
6 Report Device Fail Y
7 LTE Only N
8 Reserved N
This menu option allows you to configure various options
and functions for GSM or GPRS devices connected to the
system.
1) Press [MENU] + [6] + [5] + [1]. The keypad will
display the current RF Device Options.
Display Troubles
Report Troubles
Delay Reporting
Press OK ON OFF MENU
To Next Page
Loading...
