EasyManuals Logo

Brother DCP-8152DN User Manual

Brother DCP-8152DN
373 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #108 background imageLoading...
Page #108 background image
2-63
Confidential
îš„ Error code DD00
Fuser unit error (except error codes 6A00 to 6F00, 7600, 7800, DE00, and E200)
îš„ Error code DE00
When the center thermistor of the fuser unit is higher than the idle temperature, the side
thermistor detected a temperature lower than the specified temperature.
Print Unable DD
Turn the power off and then back on again.
<User Check>
• Turn OFF the power switch. After several seconds, turn ON the power again and check
that this error is reset.
Step Cause Remedy
1
Connection failure of the center
or side thermistor harness of
the fuser unit
Check the connection of the center or side
thermistor harness of the fuser unit, and
reconnect it if necessary.
2
Connection failure of the heater
harness of the fuser unit
Check the connection of the heater harness of
the fuser unit, and reconnect it if necessary.
3
Connection failure of the eject
sensor PCB harness
Check the connection of the eject sensor PCB
harness, and reconnect it if necessary.
4
Connection failure of the low-
voltage power supply PCB
harness
Check the connection of the low-voltage power
supply PCB harness, and reconnect it if
necessary.
5
Eject sensor PCB failure Refer to "1.3.10 Check sensor operation
(function code: 32)" in Chapter 5 to check the
sensor operation. If the sensor operation is
faulty, replace the eject sensor PCB ASSY.
6
Low-voltage power supply PCB
failure
Replace the low-voltage power supply PCB
ASSY.
7 Fuser unit failure Replace the fuser unit.
8 Main PCB failure Replace the main PCB ASSY.
Print Unable DE
Turn the power off and then back on again.
<User Check>
• Turn OFF the power switch. After several seconds, turn ON the power again and check
that this error is reset.
Step Cause Remedy
1
Connection failure of the side
thermistor harness of the fuser
unit
Check the connection of the side thermistor
harness of the fuser unit, and reconnect it if
necessary.
2
Connection failure of the eject
sensor PCB harness
Check the connection of the eject sensor PCB
harness, and reconnect it if necessary.
3
Eject sensor PCB failure Refer to "1.3.10 Check sensor operation
(function code: 32)" in Chapter 5 to check the
sensor operation. If the sensor operation is
faulty, replace the eject sensor PCB ASSY.
4 Fuser unit failure Replace the fuser unit.
5 Main PCB failure Replace the main PCB ASSY.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brother DCP-8152DN and is the answer not in the manual?

Brother DCP-8152DN Specifications

General IconGeneral
Printer TypeMonochrome Laser Printer
FunctionsPrint, Copy, Scan
Print ResolutionUp to 1200 x 1200 dpi
Duplex PrintingYes
ConnectivityUSB, Ethernet
Monthly Duty CycleUp to 50, 000 pages
Scanner TypeFlatbed with ADF
Optical ResolutionUp to 1200 x 1200 dpi
Copier ResolutionUp to 1200 x 600 dpi
Network ReadyYes
DisplayLCD
Weight16.5 kg
Print SpeedUp to 40 ppm
Paper Input Capacity250 sheets
ADF Capacity35 sheets
Maximum Paper SizeA4
Maximum Copy SpeedUp to 40 cpm

Related product manuals