2-62 2007 Buell P3: Chassis
HOME
SPROCKET COVER 2.22
REMOVAL
1. See Figure 2-104. Remove master cylinder bolts and
spacers.
2. Remove rear pedal bolt and move pedal assembly down
away from support bracket.
3. See Figure 2-105. Remove the three screws and wash-
ers on sprocket cover.
4. Slide cover free.
INSTALLATION
1. Apply Loctite 243 (blue) to threads of three screws.
2. Position sprocket cover and install three screws and
washers. Tighten fasteners to 30-36 in-lbs (3-4 Nm).
3. Move pedal assembly in position and install pedal bolt.
Tighten pedal bolt to 72-96 in-lbs (8-11 Nm).
4. Install master cylinder bolts and spacers. See 2.13
REAR BRAKE MASTER CYLINDER.
Figure 2-104. Master Cylinder Mounting
Figure 2-105. Sprocket Cover Fasteners
7704
1
1
2
2
3
1. Bolts
2. Spacers
3. Pedal bolt
a0131x2x
1. Screws (3)
2. Nylon washers (3)
1
2
To Next Page
Loading...
