Buell P3 - Specifications

2007 Buell P3: Drive/Transmission 6-1
HOME
SPECIFICATIONS 6.1
NOTE
Service wear limits are given as a guideline for measuring
components that are not new. For measurement specifica-
tions not given under SERVICE WEAR LIMITS, see NEW
COMPONENTS.
Table 6-1. Primary Drive Specifications
ITEM NEW COMPONENTS SERVICE WEAR LIMITS
PRIMARY DRIVE ENGINE-TO-TRANSMISSION
Engine sprocket – number of teeth 35 N/A
Clutch sprocket – number of teeth 56 N/A
Ratio* 1.60:1 N/A
Table 6-2. Final Drive Specifications
ITEM NEW COMPONENTS SERVICE WEAR LIMITS
FINAL DRIVE (TRANSMISSION-TO-REAR WHEEL)
Transmission sprocket – number of teeth 27 N/A
Rear wheel sprocket – number of teeth 80 Replace at 15,000 mi
(24,000 km)
Secondary drive belt – number of teeth 139 Replace at 15,000 mi
(24,000 km)
Ratio 2.96:1 N/A
Table 6-3. Transmission Specifications
ITEM NEW COMPONENTS SERVICE WEAR LIMITS
TRANSMISSION
Primary drive / transmission lubricant capacity 32 fl. oz. (946 ml) N/A
OVERALL GEAR RATIOS**
First gear (low) 12.74 N/A
Second gear 8.77 N/A
Third gear 6.79 N/A
Fourth gear 5.60 N/A
Fifth gear (high) 4.74 N/A
* Internal gear ratios indicate number of mainshaft revolutions required to drive output sprocket one revolution.
** Overall gear ratios indicate number of engine revolutions required to drive rear wheel one revolution.