Buell P3 - Page 323

6-2 2007 Buell P3: Drive/Transmission
HOME
TORQUE VALUES
Table 6-4. Clutch Specifications
WET CLUTCH/MULTIPLE DISC
CLUTCH PLATE THICKNESS NEW COMPONENTS SERVICE WEAR LIMITS
ITEM
Friction plate (fiber) (in.) 0.0866 + 0.0031 N/A
Friction plate (fiber) (mm) 2.200 + 0.079 N/A
Steel plate (in.) 0.0629 + 0.0020 N/A
Steel plate (mm) 1.598 + 0.051 N/A
Clutch pack (in.) N/A 0.413 in. (minimum)
Clutch pack (mm) N/A (16.787)
MAXIMUM ALLOWABLE WARPAGE
Friction plate (fiber) (in.) N/A 0.0059
Friction plate (fiber) (mm) N/A 0.150
Steel plate (in.) N/A 0.0059
Steel plate (mm) N/A 0.150
ITEM TORQUE NOTES
Battery terminal bolts 72-96 in-lbs 8-11 Nm Page 6-6
Clutch mainshaft nut
70-80 ft-lbs 95-109 Nm
Loctite Threadlocker 271 (red), left hand
threads, Page 6-15
Crankcase 1/4 in. screws 180-100 in-lbs 9.0-12.4 Nm Loctite Threadlocker 271 (red), Page 6-36
Crankcase 5/16 in. screws 15-19 ft-lbs 20-25 Nm Loctite Threadlocker 271 (red), Page 6-36
Engine sprocket nut 190-210 ft-lbs 258-285 Nm Loctite Threadlocker 271 (red), Page 6-15
Magnetic drain plug 14-30 ft-lbs 19-40.7 Nm Metric, Page 6-6
Primary chain limiting screw jam nut 20-25 ft-lbs 28-33 Nm Page 6-5
Primary cover bolts 100-120 in-lbs 11-14 Nm Follow torque sequence, Page 6-6
Shift lever pinch fastener 12-14 ft-lbs 16-19 Nm Page 6-6
Shifter shaft assembly locknuts
90-110 in-lbs 10-12 Nm
Bottom nut first, same torque for top, Page
6-38
Transmission sprocket nut
See NOTES See NOTES
Loctite Threadlocker 271 (red), left hand
threads, special torque turn method, Page
6-41
Transmission sprocket screws 90-110 in-lbs 10-12 Nm Replace after 3 removals, Page 6-41