7-28 2007 Buell P3: Electrical
HOME
Ignition Test 3 - Clutch Switch Function
CONDITION: Sidestand down, key ON, transmission in gear and clutch disengaged
Figure 7-32. Ignition Test 3
YES
YES
Check for ground on
TN/GN wire of clutch
switch connector [95].
Ground present?
Check for ground on
TN/GN wire of Diode 2.
Ground present?
YES
Check Diode 2 with
ohmmeter. Diode OK?
YES
Diode installed
backwards.
Reverse polarity.
Replace
diode.
YES
Repair open on TN/
GN wire between
connector [95] and
Diode 2.
NO
Replace clutch
switch.
NO
NO
Repair open on
BK wire between
connector [95] and
ground.
NO
5071
5072
5073
5074
5075
1
2
Check for ground on BK
wire of connector [95].
Ground present?
NO
NO
Repair Wiring.
System OK.
YES
Remove Seat. Remove fuse block from frame tab. Turn
fuse block upside down to access terminals. Measure
voltage between Diode 2 (-) (TN/Y) and Ignition Fuse (+)
(GY).
Is Voltage equal to Battery Voltage minus 0.7 +/- 0.1V?
Check for continuity between Socket B
(TN/Y) [134B] and Diode 2.
Is Continuity present?
To Next Page
Loading...
