29
The card (sold separately) can be an SD, SDHC, or SDXC memory
card. The captured images are recorded onto the card.
Make sure the card’s write-protect switch is set upward to
enable writing/erasing.
1
Open the cover.
Slide the cover as shown by the
arrows to open it.
2
Insert the card.
As shown by the illustration, face
the card’s label side toward you
and insert it until it clicks in place.
3
Close the cover.
Close the cover and slide it in the
direction shown by the arrows until it
snaps shut.
When you set the power switch to
<1>, the number of possible shots
(p.33) will be displayed on the LCD
monitor.
Installing and Removing the Card
Installing the Card
Write-protect switch
Possible shots
The number of possible shots depends on the remaining capacity of the
card, image-recording quality, ISO speed, etc.
Setting [1 Release shutter without card] to [Disable] will prevent you
from forgetting to insert a card (p.166).
To Next Page
Loading...
