51
A Fully Automatic Shooting (Scene Intelligent Auto)
4
Take the picture.
Press the shutter button completely to
take the picture.
X The captured image will be displayed
for approx. 2 sec. on the LCD
monitor.
If the built-in flash has popped up,
you can push it back down with your
fingers.
The focus confirmation light <o> blinks and focus is not
achieved.
Aim the AF point over an area having good contrast, then press the
shutter button halfway (p.40). If you are too close to the subject,
move away and try again.
Sometimes multiple AF points flash simultaneously.
This indicates that focus has been achieved at all those AF points.
When the AF point covering the desired subject flashes, take the
picture.
The beeper continues to beep softly. (The focus confirmation
light <o> does not light.)
It indicates that the camera is focusing continuously on a moving
subject. (The focus confirmation light <o> does not light.) You can
take sharp pictures of a moving subject.
Pressing the shutter button halfway does not focus the subject.
If the focus mode switch on the lens is set to <MF> (Manual Focus),
set it to <AF> (Auto Focus).
FAQ
The <A> mode makes the colors look more impressive in nature, outdoor,
and sunset scenes. If the desired color tone is not obtained, use a Creative
Zone mode and select a suitable Picture Style (p.81).
> mode makes the colors look more impressive in nature, outdoor,
www.devicemanuals.eu
> mode makes the colors look more impressive in nature, outdoor,
To Next Page
Loading...
