Canon LBP7010C - Page 297

If you change the settings, the toner may not fix onto paper well, and the printing may come out
faint.
Solution 2
Perform the following procedure in the printer driver.
1. Display the [Finishing] sheet.
2. Click [Advanced Settings].
3. Set [Special Print Mode] to [Special Settings C3].
If the problem is not improved, specify [Special Settings D2].
Normally, use the printer with [Special Print Mode] set to [Off]. Change the settings only if the
described problems occur.
If you specify [Special Settings D2], printing speed drops.
<Cause 6> Depending on the printer status, the paper may be creased.
Solution
Perform the following procedure in the printer driver.
1. Display the [Finishing] sheet.
2. Click [Advanced Settings].
3. Set [Special Print Mode] to [Special Settings D1].
Normally, use the printer with [Special Print Mode] set to [Off]. Change the settings only if the
described problems occur.
If you specify [Special Settings D1], toner fixation may deteriorate. In this case, do not specify
[Special Settings D1].
<Cause 7> When printing envelopes, the envelopes may crease depending on the type of the
envelopes or the operating environment (especially in a high-humidity environment).
Solution
Perform the following procedure in the printer driver.
1. Display the [Finishing] sheet.
2. Click [Advanced Settings].
3. Set [Special Print Mode] to [Special Settings B6].
Normally, use the printer with [Special Print Mode] set to [Off]. Change the settings only if the
described problems occur.
㻞㻥㻣㻌㻛㻌㻟㻠㻟