019A-06X
Perform one of the following solutions according to the cause.
<Cause 1> The envelope is inappropriate.
Solution
Replace the envelope with that which can be used with this printer.
"Usable Paper"
<Cause 2> Depending on the type of the envelopes or the operating environment (especially in
a high-humidity environment), the flaps may stick to the body of the envelopes.
Solution
Perform the following procedure in the printer driver.
1. Display the [Finishing] sheet.
2. Click [Advanced Settings].
3. Set [Special Print Mode] to [Special Settings B5].
Normally, use the printer with [Special Print Mode] set to [Off]. Change the settings only if the
described problems occur.
The Flap of the Printed Envelope Sticks
㻟㻞㻥㻌㻛㻌㻟㻠㻟
To Next Page
Loading...
