<Cause 3> Depending on the printer status, residual images may appear.
Solution
Perform the following procedure in the printer driver.
1. Display the [Finishing] sheet.
2. Click [Advanced Settings].
3. Set [Special Print Mode] to [Special Settings D1].
Normally, use the printer with [Special Print Mode] set to [Off]. Change the settings only if the
described problems occur.
If you specify [Special Settings D1], toner fixation may deteriorate. In this case, do not specify
[Special Settings D1].
<Cause 4> Depending on the paper type, images on a previous page may be printed faintly on
continuous printing
*
.
*
For example, images on the fourth page are printed faintly on the fifth page.
Solution
Perform the following procedure in the printer driver.
1. Display the [Finishing] sheet.
2. Click [Advanced Settings].
3. Set [Special Print Mode] to [Special Settings D3].
Normally, use the printer with [Special Print Mode] set to [Off]. Change the settings only if the
described problems occur.
<Cause 5> The photosensitive drum of the printer is deteriorated.
Solution
Replace the drum cartridge with a new one.
"Drum Cartridge Replacement"
㻟㻜㻥㻌㻛㻌㻟㻠㻟
To Next Page
Loading...
