216
Contents
Preparation/
Setup
Print Using a
Computer
Appendix
IndexPrint/SaveInput/Edit
Names of
Components
Maintenance/
Printer Settings
Trouble-
shooting
Problem Cause/Things to Check Solution
The cutting position is
o .
The printed area gets cut.
The tube is cut at an
angle.
Are there any objects around
the media delivery port that
prevent the media from being
ejected?
Do not place any objects around
the media delivery port. If there
is an object blocking the outlet,
the tube or label tape may not
be ejected straight and may be
cut in a bent shape.
Is there any load on the tube or
plate transport?
Place the printer and the print
media on the same table (or at
the same vertical position) so
that no load is applied to the
transport.
When using a tube reel, lighten
the load.
Is the tube twisted or warped? Correct any twists or warps
before loading.
(P.23)
If the end of the tube is bent
due to winding or other
reasons, straighten it out or
cut o the bent portion before
loading it into the printer.
Depending on your print
media and environment, the
print position may be shifted or
the length of one tube (or one
label) may be di erent from
the setting.
Make ne adjustments to the
print position and cut length.
(P.85)
If the problem is not corrected
by using the length adjust, set
the half cut to "O " and cut
with scissors.
To Next Page
Loading...
