EasyManua.ls Logo

Case WX145 - Engine Start-up Issues

Case WX145
375 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SECTION 3
3-10
ENGINE DOES NOT START
If the engine does not start, reset the ignition key to
position “0” and repeat the start-up operation.
During this operation hold the key continuously to
start-up position for at least 30 seconds. Between
one start trial and the other observe a pause of 2
minutes.
If the engine does not start even after three
attempts, check the fuel supply. The absence of
blue or white smoke from the exhaust tube during
start-up, indicates that the engine receives fuel.
Watch for the fault messages.
Maybe there is water in the fuel.
Drain water and try to start the engine again. If, after
all, the engine fails to start, address to the After-
sales service.

Table of Contents

Other manuals for Case WX145

Related product manuals