SUPPLIES AND SERVICE CHART
4-3
HYDRAULIC OIL
For the first refilling, Manufacturer uses PANOLIN
HLP SYNTH 46.
Hydraulic oil is not soluble in water; this can gener-
ate condensate water in the hydraulic oil tank.
Therefore drain condensate water periodically, par-
ticularly after a long downtime period. Dispose of
drained liquid as used oil.
VISCOSITY
Generally, multi-grade oils shall be used. In closed
heated rooms at temperatures > 5 °C (41 °F), also
single-grade oils can be used. As the viscosity of
lube oil is dependent on temperature, the choice of
SAE grade should be governed by the ambient tem-
perature prevailing at the engine operating site.
Optimum operating behaviour will be attained if you
take the accompanying oil viscosity diagram as a
guide. Should the temperature fall temporarily below
the limits of the SAE grade selected, cold starting
may be affected but the engine will not be damaged.
The application of a certain oil at higher tempera-
tures than those indicated in the chart, should be as
far as possible limited, in order to keep wear to a
minimum.
Synthetic lube oils feature an improved temperature
and oxidation stability.
2
To Next Page
Loading...
