CONTROLS AND INSTRUMENTS
2-29
STARTER SWITCH
The ignition key (1) activates following functions:
0 = No electric user is under voltage, the engine is
shut off.
A main relay disconnects all electric circuits
from the battery.
P = The cab inside light and socket, as well as the
radio, are electrically powered. All other users
are not under voltage.
I = Electrical system connected.
If the start-up is locked, the relevant code input
is required.
If the start-up is not locked, the electronic control
unit performs the self-test.
All pilot and control lights are activated for a few
seconds, the buzzer sounds shortly twice.
The display shows now some indications.
By means of the arrow buttons, you can set follow-
ing indications:
Time in hours and minutes (A) and visualization of
the operating time of the machine (B).
S WARNING S
Before starting the engine, make sure you are fully
aware of the location and the function of each con-
trol. Operating the controls wrongly can cause seri-
ous physical injury.
22
12 HOURS
23
To Next Page
Loading...
