SUPPLIES AND SERVICE CHART
4-53
SERVICE AFTER 1000 HOURS
CAB AIR FILTER - CHANGE
The filter element is accessible by opening the
cover (1) on the rear wall of the cab by means of a
square-section tool.
Open the cover (1).
Withdraw the old filter element and discard it without
polluting the environment.
Install the new filter.
Close the cover (1).
WINDSCREEN BLADES - CHANGE
For a good visibility from the operator’s side a good
cleaning of the cab windows is required.
In order to maintain this status, the good condition
and operation of the windscreen wiper blades is cru-
cial.
Change the blades for safety reasons.
SERVICE POINTS Check Cleaning Oil change
Replacement /
Change
Cab - Air filter Q
Windscreen wiper - Blades Q
Engine brackets - Screws tightening S
Engine - Belt tensioner S
Air filter: Main and safety filter elements Q
Hydraulic system - Bleeding valve Q
Steering axle
W
Rigid axle and gearbox
W
Service brake - Plates S
Pilot control filter Q
Air conditioning system S
D
Compressor belt Q
Heat exchanger - Evaporator - Condenser D
Filter and panel D
70
To Next Page
Loading...
