Case WX145 - Stabilizer System Troubleshooting

TROUBLESHOOTING
5-13
STABILIZERS
PROBLEM POSSIBLE CAUSE CORRECTION
Stabilizer not operational. Pilot control lever not in working
position.
Check and position lever correctly.
Pilot control lever defective. Consult your Dealer.
Hydraulic oil level too low. Top up hydraulic oil in correct
quantity.
Pilot control pressure limiting valve
faulty.
Consult your Dealer.
Pumps drive coupling defective. Consult your Dealer.
Primary pressure limiting valve
defective.
Consult your Dealer.
Pilot control valve operation
defective.
Consult your Dealer.
Engine inner leaks. Consult your Dealer.
Non-return valves of cylinders
defective operation.
Consult your Dealer.
Stabilizer legs not operational. Pilot control lever not in working
position.
Check and position lever correctly.
Pilot control lever defective. Consult your Dealer.
Hydraulic oil level too low. Top up hydraulic oil in correct
quantity.
Pilot control pressure limiting valve
faulty.
Consult your Dealer.
Pumps drive coupling defective. Consult your Dealer.
Primary pressure limiting valve
defective.
Consult your Dealer.
Pilot control valve operation
defective.
Consult your Dealer.
Engine inner leaks. Consult your Dealer.
Non-return valves of cylinders
defective operation.
Consult your Dealer.
Storage pressure of brake system too
low.
Check and increase the braking
pressure.
Selection of individual
stabilizer leg cylinders not
possible.
Non-return valves of cylinders
defective operation.
Consult your Dealer.
Storage pressure of brake system too
low.
Check and increase the braking
pressure.
Switch defective. Replace the switch.
Cylinders switching valve defective. Replace the valve.