CESSNA
MODEL
2088 (675 SHP)
SECTION 5
PERFORMANCE
WITHOUT
CARGO
POD
CRUISE PERFORMANCE
NOTES
The following general information is applicable to all Cruise
Performance Charts continued in Figure 5-32, Sheet 2 through Sheet
13, in this section.
1. The highest torque shown for each temperature and RPM
corresponds to maximum allowable cruise power. Do not exceed
this torque, 740°C IT, or 101.6%
Ng,
whichever occurs first.
2. The lowest torque shown for each temperature and RPM
corresponds to the recommended torque setting for best range in
zero wind conditions.
3. With the inertial separator in BYPASS and power set below the
torque limit (1865 foot-pounds), decrease the maximum cruise
torque by 115 foot-pounds. Do not exceed 740°C ITT. Fuel flow
for a given torque setting will be 15 pph higher.
4. With the cabin heat on and power set below the torque limit (1865
foot-pounds), decrease maximum cruise torque by 80 foot-
pounds. Do not exceed 740°C IT. Fuel flow for a given torque
setting will be 7 pph higher.
Figure 5-32. Cruise Performance (Sheet
1
of 13)
='
=,
=,
--,
~3
~-
-3
9
rl
-3
:#
e
5
-*
-
1
Revision 23
d
.
,
U.S. 5-73
To Next Page