SECTION
8
CESSNA
HANDLING, SERVICE, AND
MAINTENANCEMODEL 2088 (675 SHP)
GROUND HANDLING
(Continued)
OIL
(Continued)
NOTE
The oils listed above are recommended when operation will
result in frequent cold soaking at ambient temperatures of
0°F (-18°C). Refer to Pratt
& Whitney Engine Service
Bulletin No. 1001 for additional oils which are approved.
If one or more of the following conditions exist, the accessory gearbox
scavenge pump inlet screen and any drained oil should be inspected
for the presence of carbon particles, per airplane and engine
maintenance manual procedures and the engine manufacturer's
pertinent engine and oil service bulletins:
1. Engine oil has been switched to a "third generation" lubricant
during mid-life.
2. High oil consumption.
3.
Oil leaking from engine intake.
If carbon particles are found, refer to the above referenced
maintenance manuals and service bulletins for corrective action.
TOTAL OIL CAPACITY
-
14 U.S. Quarts (including oil in filter, cooler
and hoses).
DRAIN AND REFILL QUANTITY
-
Approximately 9.5 U.S. Quarts.
OIL QUANTITY OPERATING RANGE:
Fill to within
1
112
quarts of
MAX
HOT or
MAX
COLD (as
appropriate) on dipstick. Quart markings indicate U.S. quarts low if
oil is hot. For example, a dipstick reading of 3 indicates the system is
within 2 quarts of MAX, if the oil is cold and within 3 quarts of MAX if
the oil is hot.
(Continued Next Page)
Revision 23
To Next Page
Loading...
