Check Point UTM-1 Edge - Page 175

Configuring Network Settings
Chapter 6: Managing Your Network 161
The Edit Network Settings page for the LAN network appears.
3. In the Mode drop-down list, select Enabled.
The fields are enabled.
4. If desired, change your UTM-1 appliance’s internal IP address.
See Changing IP Addresses on page
162.
5. If desired, enable or disable Hide NAT.
See Enabling/Disabling Hide NAT on page
163.
6. If desired, configure a DHCP server.
See Configuring a DHCP Server on page
164.
7. Click Apply.
A warning message appears.
8. Click OK.
A success message appears.