Using Static Routes
206 Check Point UTM-1 Edge User Guide
6. Click Next.
The new static route is saved.
Table 37: Static Route Fields
In this field… Do this…
Source Specify the source network (source routing). This can be either of the
following:
• ANY. This route applies to packets originating in any network.
• Specified Network. This route applies to packet originating in a
specific network. The Network and Netmask fields appear.
Source -
Network
Type the source network's IP address.
Source -
Netmask
Select the source network's subnet mask.
Destination Specify the destination network. This can be either of the following:
• ANY. This route applies to packets sent to any network.
• Specified Network. This route applies to packets sent to a specific
network. The Network and Netmask fields appear.
Destination -
Network
Type the destination network's IP address.
Destination -
Netmask
Select the destination network's subnet mask.
To Next Page
Loading...
