Using Static Routes
Chapter 6: Managing Your Network 207
In this field… Do this…
Service Specify the service used to send packets (service routing). This can be
either of the following:
• ANY. This route applies to packets sent using any service.
• A specific service.
Note: When defining a static route for a specific service, the Source and
Destination fields must be set to ANY.
Next Hop IP Specify the next hop to which packets should be sent. This can be any of the
following:
• Specified IP. Traffic matching this static route's criteria will be
routed to a specific gateway. Type the IP address of the desired
gateway (next hop router) in the field provided.
• WAN (Internet). Traffic matching this static route's criteria will be
routed to the Internet connection on the WAN1 interface.
• WAN2 (Internet). Traffic matching this static route's criteria will be
routed to the Internet connection on the WAN2 interface.
Metric Type the static route's metric.
When a packet matches multiple static routes' criteria, the gateway sends the
packet to the matching route with the lowest metric.
The default value is 10.
To Next Page
Loading...
