Check Point UTM-1 Edge - Page 233

Managing Ports
Chapter 6: Managing Your Network 219
Resetting All Ports to Defaults
To reset all ports to defaults
1. Click Network in the main menu, and click the Ports tab.
The Ports page appears.
2. Click Default.
A confirmation message appears.
3. Click OK.
All ports are reset to their default assignments and to "Automatic Detection" link
configuration.
Resetting Individual Ports to Defaults
To reset a port to defaults
1. Click Network in the main menu, and click the Ports tab.
The Ports page appears.
2. Next to the desired port, click Edit.
The Port Setup page appears.
3. Click Default.
A confirmation message appears.
4. Click OK.
The port is reset to its default assignment and to "Automatic Detection" link
configuration.