Using Rules
344 Check Point UTM-1 Edge User Guide
In this field… Do this…
Destination Select the destination of the connections you want to allow/block.
To specify an IP address, select Specified IP and type the desired IP address
in the text box.
To specify an IP address range, select Specified Range and type the desired
IP address range in the fields provided.
To specify the UTM-1 IP address, select This Gateway.
To specify any destination except the UTM-1 Portal and network printers,
select ANY.
If the current time
is
Select this option to specify that the rule should be applied only during
certain hours of the day.
You must then use the fields and drop-down lists provided, to specify the
desired time range.
Forward the
connection to
Select the destination to which matching connections should be forwarded.
To specify an IP address, select Specified IP and type the desired IP address
in the text box.
This field only appears when defining an Allow and Forward rule.
Quality of
Service class
Select the QoS class to which you want to assign the specified connections.
If Traffic Shaper is enabled, Traffic Shaper will handle these connections as
specified in the bandwidth policy for the selected QoS class. If Traffic Shaper
is not enabled, this setting is ignored. For information on Traffic Shaper and
QoS classes, see Using Traffic Shaper.
This drop-down list only appears when defining an Allow rule or an Allow and
Forward rule.
To Next Page
Loading...
