Using Rules
Chapter 12: Setting Your Security Policy 345
In this field… Do this…
Redirect to port Select this option to redirect the connections to a specific port.
You must then type the desired port in the field provided.
This option is called Port Address Translation (PAT), and is only available
when defining an Allow and Forward rule.
Log accepted
connections /
Log blocked
connections
Select this option to log the specified blocked or allowed connections.
By default, accepted connections are not logged, and blocked connections
are logged. You can modify this behavior by changing the check box's state.
Enabling/Disabling Firewall Rules
You can temporarily disable a user-defined rule.
To enable/disable a firewall rule
1. Click Security in the main menu, and click the Rules tab.
The Rules page appears.
2. Next to the desired rule, do one of the following:
• To enable the rule, click
.
The button changes to
and the rule is enabled.
• To disable the rule, click
.
The button changes to
and the rule is disabled.
To Next Page
Loading...
