Web Filtering
458 Check Point UTM-1 Edge User Guide
Configuring Web Filtering Advanced Settings
Note: If the UTM-1 appliance is remotely managed, contact your Service Center
administrator to change these settings.
To configure Web Filtering advanced settings
1. Click Services in the main menu, and click the Web Filtering tab.
The Web Filtering page appears.
2. Next to the Bypass scanning if Service Center is unavailable option, specify
how the gateway should handle Web Filtering when the service is enabled and
the Service Center is unavailable, by doing do one of the following:
• To temporarily block all connections to the Internet, click
.
This ensures that users will not gain access to undesirable Web sites, even when
the Service Center is unavailable.
The button changes to
.
• To temporarily allow all connections to the Internet, click
.
This ensures continuous access to the Internet.
The button changes to
.
When the Service Center is available again, the gateway will enforce the configured
Web Filtering policy.
To Next Page
Loading...
