Check Point UTM-1 Edge - Page 568

Using RADIUS Authentication
554 Check Point UTM-1 Edge User Guide
specific users. If the VSA is configured for a user, then the RADIUS server passes the
VSA to the UTM-1 appliance as part of the response to the authentication request, and the
gateway assigns the user permissions as specified in the VSA. If the VSA is not returned
by the RADIUS server for a specific user, the gateway will use the default permission set
for this user.
In addition, you can configure the RADIUS server to pass the UTM-1 appliance a Secure
HotSpot session timeout value. When the RADIUS server's Session-Timeout Attribute is
configured, HotSpot users will be logged off after the specified session timeout has
elapsed.
To use RADIUS authentication
1. Click Users in the main menu, and click the RADIUS tab.