Cisco 7000 - Page 283

Reading LED Indicators B-279
Interface Processor LEDs
TRIP LEDs
The TRIP LEDs are shown in Figure B-15. Each horizontal row of three LEDs, one for each Token
Ring interface, indicates the speed (4 or 16 Mbps) of the interface and whether the interface is
inserted into the ring.
Figure B-15 TRIP LEDs
All TRIPs, regardless of whether they provide two or four ports, contain the bank of LEDs shown in
Figure B-15. As with the other interface processors, the enabled LED goes on to indicate that the
TRIP is enabled for operation. Three LEDs for each port indicate the following:
• 16 Mbps—Lights when the interface is operating at 16 Mbps.
• 4 Mbps—Lights when the interface is operating at 4 Mbps.
• In ring—When on, indicates that the interface is currently active and inserted into the ring. When
not on, indicates that the interface is not active and is not inserted into a ring.
H1367a
ENABLED
0
1
2
3
IN RING
4 Mbps
16 Mbps