Cisco D9824 User Manual

Chapter 4 Front Panel Operation
110
Menu Item
Description
Parameters
UDPPort
This selects the destination port
number.
1 to 65534
Note: If you selected RTP for MOIP,
you must select an even destination
port number.
Note: It is not recommended that you
use destination UDP ports reserved
by the IANA.
SrcPort
This selects the source UDP
port number.
0 to 65535
Note: Set the SrcPort to 0 to use the
default source UDP port (49162).
Send SAP
This selects whether to send
Session Announcement
Protocol messages.
None or RFC2327
SAP Multicast
Address
This is the IP address where the
SAP announcements are sent, if
required.
It is not recommended that you
change the default IP address
(224.2.127.254).
SAP Port
This is the UDP port where the
SAP announcements are sent, if
required.
1 to 65534
Note: It is not recommended that you
change the default SAP port 9875.
SAP ID
Describes the SAP output
stream name source.
User String or SDT Channel
SAP User Str
Provides the SAP user string.
Up to 31 characters
FEC
Select the error protection
profile.
For more information, see
Configuring Forward Error
Correction Settings (on page
230).
1D - Requires generation of one FEC
protecting stream: columns.
2D - Requires generation of two FEC
protecting streams: columns and
rows.
None - Disables the error protection.
Note: For more information, see
SMPTE 2022-1-2007.
FEC1 UDP
Enter the destination UDP port
number of the columns FEC
stream.
2 to 65534, even number only
FEC2 UDP
Enter the destination UDP port
number of the rows FEC
stream.
2 to 65534, even number only
FEC Columns (L)
Set the spacing between non-
consecutive packets used to
calculate the FEC packet.
1 to 20
FEC Rows (D)
Set the depth of the FEC matrix.
4 to 20

Cisco D9824 Specifications

General

Brand	Cisco
Model	D9824
Category	Receiver
Language	English